Fitting new "Caterham" decals on side panels

5 posts / 0 new
Last post
Ian28
Ian28's picture
Offline
Last seen: 9 hours 5 min ago
Joined: 21/09/2016
Fitting new "Caterham" decals on side panels
Anyone tried fitting new decals with the exhaust can in place? Car is a sigma SV so access to near side is straight forward. Is it possible to fit the offside without removing the standard exhaust? Top tips and suggestions welcome
356DNA
Offline
Last seen: 4 hours 27 min ago
Joined: 10/09/2019

I just did mine (duratec) and concluded the only sensible way was to remove the exhaust from the collector back. It was tricky enough lining everything up and measuring spacing without the can and cat in the way. 

356DNA
Offline
Last seen: 4 hours 27 min ago
Joined: 10/09/2019

Sorry. Feel such a Luddite but I can’t rotate this image from my phone...

Jonathan Kay
Jonathan Kay's picture
Online
Last seen: 39 sec ago
Joined: 17/04/2014

It's not you.

Jonathan

pugwash
pugwash's picture
Offline
Last seen: 2 hours 56 min ago
Joined: 17/04/2014

It's only one bolt and one clamp to remove the silencer so would make sense to do that.  Plus two springs if you want the collector / cat  off.  Oh and unplug the lambda sensor cable.