S3 and Duratec parts wanted

[Jochen]

To realize a new project over the next few years i am looking for some parts. Preferably used or affordable new. 

 

GRP nose cone with air ducts at top and below. Condition and color doesn’t matter.

Quaife LSD and cover for 7 inch Ford Sierra diff 

Caterham Aero fuel cap black 

Jenvey dth Duratec 48mm throttle bodies with 90mm trumpets, linkage and bracket

Raceline or Caterham dry sump system with internal pump

Caterham / Brise / Pace Duratec triangular dry sump tank

Duratec clutch cover

done Caterham / Raceline Duratec oil filter housing

Gearknob 5 speed black 

Duratec head 

Raceco silencer

Raceline Duratec-R cam cover

And last but not least i am searching for an S3 donor car. Maybe a total loss (race ?) car with damaged engine, accident or best both. Duratec prefered.

Kind regards from Germany,

Jochen

 

[Andy Doughty]

Hi Jochen

I have a couple of the older spec Duratec heads, one of which suffered a bit of valve clash! They both probably need new guides and a refresh before use.

I also have one of the original Ford alloy cam covers which has been crinkle painted.

also an engine with crank and all parts but dismantled although it has a mark on one of the bores where water got into one of the bores and caused a bit of surface damage. I think it would rebore OK.

if you are interested I can get them out of storage and send you pictures.

Cheers

Andy Doughty

 

[garybee]

I have a spare Caterham Duratec lightweight flywheel if you're interested.  

[Jochen]

Hi Andy, 

i‘m afraid the orign cam cover is too high to use it with a 2.3 or 2.5 Block. Even a 2.0 engine is not useable.

Maybe i get in touch with you if I find no undamaged later spec head.

Best regards,

Jochen

 

[Jochen]

Hello Gary,

i have a Cosworth aluminium flywheel with 230mm friction face diameter. Only need an matching spring loaded cerametallic paddle clutch plate for it.

[vander]

Hi Jochem,

I haver a 2.0 duratec decat pipe and R500 silencer lying around if you are interested. 

PM me if you are interested. 

Best,

Andrew