Fitting new "Caterham" decals on side panels

6 posts / 0 new
Last post
Ian28
Ian28's picture
Offline
Last seen: 10 hours 9 min ago
Joined: 21/09/2016
Fitting new "Caterham" decals on side panels
Has anyone fitted/replaced caterham side decals/stripes with the exhaust can in place? Car is a Sigma SV so nearside is easy access. Offside/driver's side looks very tight access without first removing the exhaust and Cat. Has anyone managed to fit them with exhaust in place ? Top tips and suggestions welcome.
356DNA
Offline
Last seen: 5 hours 32 min ago
Joined: 10/09/2019

Sure I replied and the post vanished. However. I did this the other day. No matter how I looked at it exhaust and cat removal from the collector back was the only prudent option. It’s quite hard to line up the decals at floor height anyway and so additional obstructions seemed unnecessary. 

Its one bolt, one clamp, 2 spring clips and a bit of wiggling. I tucked the decat pipe and lambda sensor under the car. 

356DNA
Offline
Last seen: 5 hours 32 min ago
Joined: 10/09/2019

356DNA
Offline
Last seen: 5 hours 32 min ago
Joined: 10/09/2019

Helps to hang the car sideways also. 

Jonathan Kay
Jonathan Kay's picture
Online
Last seen: 2 min 44 sec ago
Joined: 17/04/2014

Sure I replied and the post vanished.

Still here, but it's in another forum... the question was asked twice.

Jonathan

Mark_
Mark_'s picture
Offline
Last seen: 5 hours 34 min ago
Joined: 21/10/2018

Its doable, but if you CBA, take the exhaust off.....

I did mine but sometimes wonder why I bothered witht hat exhaust side as its virtually invisible from sideon....