fitting rear badges

[miles.gray]

before I bugger it up, how do these badges get applied?  Are they just peel the back off and apply?  Soak them in water?  I know this is a really dumb question... but I'm really dumb.  Thanks in advance!/sites/default/files/images/users/40423/DSC_0001.JPG

[Kingsley Young]

Miles

What you have to do is peel the backing paper off very very carefully , you have to make sure that the letters stay attached to the top paper, if the letters are lifting off the top paper ,then lay it back onto the letters with your thumb nail. Once you have got all the the letters on the top paper then you are ready to stick them into position.  

The adhesive is on the underside of the letters and each letter is individual , not in a block. 

I hope this helps. 

Kingsley. 

[miles.gray]

thanks, much appreciated.

[John Vine]

In case you haven't already noticed, the "T" in "CATERHAM" looks a bit wonky.

JV

[Toughie]

I've always found it to be a bit wonky having tea in a Caterham.

Don't drink and drive - you spill hot tea in your lap.

[dave_h34]

Not so easy to do with those but if you put a bit of masking tape along the top you can have a few goes at getting the alignment on the car right. When you're happy with it, flap the whole lot up, remove the backing paper then flap it back down to stick the actual decal.